Is this calc correct?

[JustANormalLemon]

I was looking some Club Penguin calcs and noticed this one that when It's time to put the Radious of the explosion in the formula the entire height of the explosion is inserted, is this correct sinse we don't really see the full explosion?

idk if this is the right place to ask this

 

[Vzearr]

No it’s bunk. Using the furthest line doesn’t make sense, as it assumes that the explosion doesn’t have lines, use the clear circle of the explosion. There are also several other problems, sorry.

 

[JustANormalLemon]

No it’s bunk. Using the furthest line doesn’t make sense, as it assumes that the explosion doesn’t have lines, use the clear circle of the explosion. There are also several other problems, sorry.

But is the line eing used as the radios one of the problens?

 

[Vzearr]

But is the line eing used as the radios one of the problens?

What.

 

[JustANormalLemon]

What.

Sorry, It's late at might here

The explosion calc uses a single line to measure It's size, being 532 pixels long, but when passing trough th explosion yield formula It uses this same line as the radius of the explosion, I want to know if this is right or wrong

 

[Vzearr]

Sorry, It's late at might here

The explosion calc uses a single line to measure It's size, being 532 pixels long, but when passing trough th explosion yield formula It uses this same line as the radius of the explosion, I want to know if this is right or wrong

That’s completely wrong.

 

[JustANormalLemon]

That’s completely wrong.

So should be half of the lenght of this line, right? Or shld have gotten the explosion diameter of the explosion as a whole first?

 

[Vzearr]

So should be half of the lenght of this line, right? Or shld have gotten the explosion diameter of the explosion as a whole first?

You should have gotten the diameter first. However if that’s not possible, cut the diameter you calculated here in half and make sure not to scale to the lines.

 

[JustANormalLemon]

You should have gotten the diameter first. However if that’s not possible, cut the diameter you calculated here in half and make sure not to scale to the lines.

not my calc but thanks