Tier for spiltting a hill?

[The_Pink_God]

Hills can vary from 100 to 500 feet
So I would like to know what tier would be splitting a 100 feet hill
A 250 feet hill
And finally a 500 feet hill

 

[EmilioRory10]

Bruh I was about to finish calculating this and I accidentally deleted it

 

[The_Pink_God]

Bruh moment

 

[EmilioRory10]

Anyway, I don't think I could get actual results for this since Idk what Ugarik was referring to when they replied to the Tanjiro calc (of course I did some assumptions such as it being cut with an average blade), but the results I remember getting were

100 feet: Around 7.3 tons of tnt
250 feet: 45.6 tons of tnt I think (6.24 times higher so I could assume this is a pretty linear thing (2.5*2.5 = 6.25), which when assuming that I get the 500 feet result to be 182.4 tons of tnt)

 

[The_Pink_God]

 

[The_Axiom_of_Virgo]

Anyway, I don't think I could get actual results for this since Idk what Ugarik was referring to when they replied to the Tanjiro calc (of course I did some assumptions such as it being cut with an average blade), but the results I remember getting were

100 feet: Around 7.3 tons of tnt
250 feet: 45.6 tons of tnt I think (6.24 times higher so I could assume this is a pretty linear thing (2.5*2.5 = 6.25), which when assuming that I get the 500 feet result to be 182.4 tons of tnt)

So Tl;dr:
High 8-C
8-B
8-A

I have to admit while I'm not surprised that a slicing a large hill is MCB level, I am a little surprised how low slicing a small hill is then again some earthquakes are only High 8-C too, so it makes sense I guess?

 

[The_Pink_God]

Damn I kinda wanted a blog with the calc
But knowing Calculation Requests, better not :/